|
Post by psychedelicropcircle on Jan 7, 2012 13:51:04 GMT 1
Any of you S3 owners know how to get that screw/ nail out the elbow? Sticky book down the hoose. Attachments:
|
|
|
Post by shep on Jan 7, 2012 15:53:46 GMT 1
the last time i looked , it 's a long bolt wi a wing nut holdin on yur filter ,undo the wing nut n the bolt should come oot
|
|
|
Post by psychedelicropcircle on Jan 7, 2012 17:50:34 GMT 1
Is the wing nut supposed to be attached to the bit that looks like a nail? It would make sense as there is a groove cut into the head on the ( nail).
|
|
|
Post by shep on Jan 7, 2012 18:08:35 GMT 1
aye the opposite end o the bit yi yin see
|
|
|
Post by psychedelicropcircle on Jan 7, 2012 21:05:12 GMT 1
Wot you see is all you can get at to the best of my knowledge. Wouldnt be surprised if the wingnut snapped off....yoan "ped" has been mistreated.
|
|
|
Post by skin on Jan 7, 2012 22:45:45 GMT 1
jist prize the 2 parts apart "the u bend" & the white box "air box" it looks like the wire clip is off, so must jist be stuck together by the rubber seal, when apart you see how the filter is held oan the u bend mahaga
|
|
|
Post by psychedelicropcircle on Jan 8, 2012 21:59:29 GMT 1
Think you might be right mahaga really just want it apart so I can get it sent away with everything else to the blasters. Only got the toolbox door lock to remove then it ready to go.
|
|
|
Post by skin on Jan 8, 2012 23:07:15 GMT 1
dont suppose u b using airbox oan new setup are you ? if your no gettin it powder coated, get it etch primed efter blastin cuzin
|
|